Wolfie wrote:Those trips can be given open can surgery, the little tabs just bend up and Robert is yer mothers brother..
I'm sure a man of your calibre would soon see why it doesn't perform.
malcscott wrote:Check the 680k next to the A1 pots.
malcscott wrote:The A1 pots are on the convergence panel at the top of the set. The drive pots are on the RGB panel. Malc.
malcscott wrote:A 1meg will do if your stuck.
malcscott wrote:If the trip is also o/c or int o/c on the bcl side, it will destroy the two transistors in the bcl cct and the bcl pot on the rgb panel. Also replace the 100mfd cap on the eht tower next to the PL509 base, check the 1k next to it, Malc.
marc wrote: I'm guessing the valve still has good vacuum as it still glows and hasn't started going white but never the less it will need changing.
malcscott wrote:Check A1 volts on A1 pots 550v - 600v. Try adjusting the bcl pre-set rv303 on the rgb panel. There is also a pre-set brill pot on the small t/base panel at the bottom of the set, RV405. Try adjusting it, if the A1 volts are low there is a 220k resistor and a 0.01mfd cap on the small pcb inside the eht tower. Suspect these, Malc.
Users browsing this forum: No registered users and 1 guest