Red to black wrote:I looked at Gary's thread and the replacement cap is sized very similar to the originala
Red to black wrote:I was asking for others opinions on this too
CrustyTV wrote:Red to black wrote:I looked at Gary's thread and the replacement cap is sized very similar to the originala
Actually they are totally different in size, I know as I bought some when Gary did and have the old 5n1 for actual comparison.Red to black wrote:I was asking for others opinions on this too
No worries, I'll take the hint and back off now
nuvistor wrote:If any doubt it's back to manufactures spec sheets, if the specs state it will handle the load then that's ok. Unfortunately the specs very often don't cover what you need.and then it's what you know work.
Large AC currents, will tend to warm the capacitor and can be judged if ok. Large spikes are different, it will just breakdown without warning, some mixed dielectric capacitors common in late 60's early 70's had high working voltage, 1000Vdc but did not like line timebases with the spikes, or across the mains supply.
If you have found a type that works then carry on, that's experience, otherwise use caution.
Red to black wrote:Cathy what those data sheets don't show is the duty cycle
Red to black wrote:nor dissipation rates
Red to black wrote:as I am not a circuit designer and only a (former) mender I can only go by experience and my training, now I could well be wrong as I have said already.
I suppose the only way is to suck it and see as we are also not privvy to Thorns original design criteria
Red to black wrote:Ps. similar general rules of thumb apply to the snubber caps in Switched Mode PSUs.
see, I am a mine of useless information lol
CrustyTV wrote:Well the proof they say is in the pudding.
I've had the set on for 15mins and the new flyback tuning cap is cold to the touch. I will leave it even longer but certainly I believe its more than up to the job.
CrustyTV wrote:Back to the matter in hand, after replacing the blown resistor R528, replacing C511 and reinstating the broken beam limiter earth to LTB. No change still on hoz lock. The tuner has all but fallen apart and may not be helping three of the selectors are locked in and one seems to tune but I'm not happy with it. I might see if I have a spare tuner in stock, then again I might just put this to one side.
Users browsing this forum: No registered users and 2 guests